Section: 3D GEOMETRY CHALLENGE | 3D GEOMETRY CHALLENGE | Vectorworks University

Due to scheduled maintenance, the Vectorworks University will be unavailable on November 11 starting at 3:00 PM EDT. The site will be unavailable for approximately 1 hour.

Courses Certifications Dashboard

Section outline

Select section 3D GEOMETRY CHALLENGE
DESCRIPTION

In this challenge, we would like you to use this time to concentrate on using the 3D geometry tools to create multiple different shapes. Go wild with push/pull and the extrude command. Use this time to be as creative as you like with the 3D tools you have learnt.

OBJECTIVE

The objective for this guided practise is check your understanding of the 3D tools you have learnt about and to give you the time to practise.

SKILLS NEEDED

Rectangle Tool

Circle Tool

Extrude Command

Push/Pull Tool

Push/Pull Mode

Introduction to Planes

TO START

Within Vectorworks open a new template file by going to File > New > Use Document Template > Use the Fundamentals Metric or Imperial Template. (Remember to save your file!)